Use of vibrating motor pay attention to what issues

1 , anchor bolts loosening problems
This is caused by the vibration motor burned one of the major failures due to the special structure of the vibration motor itself , its ends eccentric excitation force generated

per minute to two thousand times the vibrating screen supplier impact on the bolt, and then due to the vibration of the motor itself part of the vibration , it is very easy to loose bolts ,

Once a loose bolts in a short period of time will cause other bolts loose, and even rupture , thus burning motor .
Preventive measures: ① often reinforced bolt ; ② increased locking devices ; ③ foot and motor ground floor to ensure good contact , even by force to make a few bolts .
In the selection , try using one of the seat vibration screen shell vibration motor ( ie, to foot the chassis ) , place one foot is processed, it can ensure its standards. The seat shell

allogeneic ( ie, to the foot end caps at both ends ) , due to the foot is a graded processing, re- assembled, the assembly error

The presence of poor , difficult to guarantee the level of the foot , so a few bolts evenly by the force will not be easy , but by a larger force of a bolt is easy to loose,

thus causing the other bolts loose, broken , burned the motor.
2 , Installation Issues
Because vibration motor at both ends with heavy eccentric , such as vertical or inclined installation ( ie, vertical or inclined axis horizontal ) , the bearing axial eccentric

block to withstand gravity . If no special device in vibration motor ( ie plane bearing ) , it will adversely affect the bearing , thus shrinking

Short life.
Preventive measures: ① Select the vertical vibration motor ( ie increase inside plane bearing ); ② Avoid vertical or inclined installation.
3 , eccentric adjustment
Adjust the eccentric block, mistakenly tune ends eccentric direction reversed, so that the vibration motor torque generated a space , so that the vibration motor work in a non-

normal state , thereby causing burned. Therefore, adjusting the eccentric block , be sure to pay attention to its symmetry , that both ends of the eccentric block corresponding

to twenty-two

, Or that both ends of the center of gravity of the eccentric shaft parallel with the cable , can not be a different surface states.
4 , protective cover sealing problems
Since most of the vibration motor is very poor working conditions , dusty , if shields Mifengbuyan easily into the dust , causing friction eccentric operation , thus burning

motor . So bad place in the work environment , a protective cover to increase the seal , two should always clear

Li shield inside the dust.
Through the above explanation, if there is any questions, you can then ask us.